Vehicle Make

2010 Dodge Avenger Remote Programming instructions

Need A Refurbished Key Come Check Out Our
Refurbished On-line Key Store

visit our store

Shear These Programming Instructions

**This procedure CAN ONLY be used on vehicles built in USA.

**You MUST HAVE two working programmed Remote/keys before
you can add a third remote/key.

**If you only have ONE WORKING REMOTE/KEY and want to add a
second key this procedure WILL NOT WORK.

*** Click here to Find a Locksmith in your area to program remote/key
if you only have one or none working remote/keys

1. Using first programmed remote/key turn ignition to the ON position
for 5 seconds. (Do not crank engine). Turn remote/key off and remove.

2. Within 5 seconds insert second working programmed remote/key.
Turn ignition to the ON position (Do not crank engine) security light
will begin to flash and chime will be heard within 10 seconds. Turn
remote/key off and remove. NOTE: Some vehicles will not chime,
only the security light will flash.

3. Within 5 seconds insert third NEW CUT remote/key and turn ignition to
the ON position (Do not crank engine). The security light should start
flashing and within 10 seconds you should hear a chime and the
security light should go out. Once the security light goes out, the new
remote/key should be programmed. Turn remote/key to the OFF
position, remove key.

4. Test key and remote.