2009 Nissan Xterra Remote Programming instructions
Shear These Programming Instructions
1. Close and lock all doors with the driver's side power lock / unlock switch located
on drivers door panel.
2. Insert key into ignition and remove it from the ignition key cylinder at least 6 times
within 10 seconds. Your hazard lamps will flash if you have performed this step
successfully. NOTE: Withdraw key completely from ignition cylinder each time. If
this procedure is performed to fast, system will not enter programming mode.
3. Insert key into ignition and turn to the ACC position.
4. Within 5 seconds, push ANY button oon the keyless remote. Your hazard lamps
will flash. NOTE: Do not press the button on the remote more than one time or the
programming will not be successful.
5. If there are any remaining remotes (including old ones), Unlock then Lock all doors
using switch on drivers door panel and within 5 seconds press ANY button on the next
remote. Your hazard lamps will flash. Repeat this step for each remote (including any
6. Turn key to the off position, remove key from the ignition. Unlock door using switch on
door panel and open drivers door.
7. Test remote(s).Disclaimer