Vehicle Make

2009 Nissan Titan Remote Programming instructions

Need A New Key Come Check Out Our
BRAND NEW ONLINE KEY STORE

visit our store

Shear These Programming Instructions



IMPORTANT: Before entering programming mode, have in possession all of the transmitters
you will be using on the vehicle. Once you program the transmitter, all previous codes will
be erased from the memory. The other transmitters will not be functional until you program
the transmitters again.

1. Close and lock all doors with the driver’s side power lock/unlock switch.

2. Insert key into ignition and remove it from the ignition key cylinder at least six times
within 10
seconds. Your
Hazard Lamps will flash if you have performed this step
successfully. NOTE: Withdraw key completely from
ignition cylinder
each time. If this
procedure is performed too fast, system will not enter programming mode.

3. Insert key into the ignition cylinder and turn to the ACC position.

4.
Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should
flash.
NOTE: Do not press
the button more than one time in the above step. If the button
is pressed more than one time, the programming
procedure will not be successful.


5. If there are any remaining transmitters (including the old ones), unlock then lock all doors
using the
driver’s side
power lock/unlock switch and within 5 seconds, push ANY button
on the next remote. Your Hazard
Lamps should
flash. Repeat this step for each
transmitter (including any existing transmitters).

6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the
driver’s side power lock/unlock switch and open the driver side door.

Disclaimer