2009 Dodge Ram 1500 Remote Programming instructions
Need A Refurbished Key Come Check Out Our
Refurbished On-line Key Store
Shear These Programming Instructions
Use procedure #1 if your Ram has Remote/Key
Use procedure #2 if your Ram has a FOBIK
Procedure #1
*This procedure CAN ONLY be used on vehicles built in USA.
**You MUST HAVE two working programmed Remote/keys before
you can add a third remote/key.
**If you only have ONE WORKING REMOTE/KEY and want to add a
second key this procedure WILL NOT WORK.
*** Click here to Find a Locksmith in your area to program remote/key
if you only have one or none working remote/keys.
1. Using first programmed remote/key turn ignition to the ON position
for 5 seconds. (Do not crank engine). Turn remote/key off and remove.
2. Within 5 seconds insert second working programmed remote/key.
Turn ignition to the ON position (Do not crank engine) security light
will begin to flash and chime will be heard within 10 seconds. Turn
remote/key off and remove. NOTE: Some vehicles will not chime,
only the security light will flash.
3. Within 5 seconds insert third NEW CUT remote/key and turn ignition to
the ON position (Do not crank engine). The security light should start
flashing and within 10 seconds you should hear a chime and the
security light should go out. Once the security light goes out, the new
remote/key should be programmed. Turn remote/key to the OFF
position, remove key.
4. Test key and remote.
Procedure #2
**You MUST HAVE two working programmed transmitters before
you can add a third transmitters.
**If you only have ONE WORKING TRANSMITTER and want to add a
second transmitter this procedure WILL NOT WORK.
*** Click here to Find a Locksmith in your area to program transmitter
if you only have one or none working transmitters.
1. Using first programmed transmitter turn ignition to the ON position
for 3 seconds but no longer than 15 seconds.
(Do not crank engine). Turn transmitter off and remove.
2. Within 15 seconds insert second working programmed transmitter.
Turn ignition to the ON position (Do not crank engine) After 10 seconds
an acoustic signal will be heard and immobilizer warning lamp wil
flash. Turn transmitter OFF and remove second programmed
transmitter.
3. Within 60 seconds insert third NEW non-programmed transmitter into
ignition and turn to the ON position (Do not crank engine).
After 10 seconds an acoustical signal will be heard and immobilizer
warning lamp will illuminate for 3 seconds.
4. Turn transmitter to the OFF position and remove.
5. Test transmitters.
Repeat procedure for additional transmitters if required.
A maximum of 8 transmitters can be programmed.
