Vehicle Make

2008 Dodge Magnum Remote Programming instructions

Need A New Key Come Check Out Our
BRAND NEW ONLINE KEY STORE

visit our store

Shear These Programming Instructions



**You MUST HAVE two working programmed transmitters before
you can add a third transmitters.

**If you only have ONE WORKING TRANSMITTER and want to add a
second transmitter this procedure WILL NOT WORK.

*** Click here to Find a Locksmith in your area to program transmitter
if you only have one or none working transmitters
.

1. Using first programmed transmitter turn ignition to the ON position
for 3 seconds but no longer than 15 seconds.
(Do not crank engine). Turn transmitter off and remove.

2. Within 15 seconds insert second working programmed transmitter.
Turn ignition to the ON position (Do not crank engine) After 10 seconds
an acoustic signal will be heard and immobilizer warning lamp wil
flash. Turn transmitter OFF and remove second programmed
transmitter.

3. Within 60 seconds insert third NEW non-programmed transmitter into
ignition and turn to the ON position (Do not crank engine).
After 10 seconds an acoustical signal will be heard and immobilizer
warning lamp will illuminate for 3 seconds.

4. Turn transmitter to the OFF position and remove.

5. Test transmitters.

Repeat procedure for additional transmitters if required.
A maximum of 8 transmitters can be programmed.

Disclaimer