Vehicle Make

2001 Toyota Avalon Remote Programming instructions

Need A New Key Come Check Out Our
BRAND NEW ONLINE KEY STORE

visit our store

Shear These Programming Instructions



2001 Avalon


1. Start with key out of the ignition, driver door is open (all others closed), and driver
door is unlocked.

2. Insert key into the ignition (don’t turn it) and pull it out

3. Perform these steps within 40 seconds:

a. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles
starting
with lock.
Use an even pace and try to go about one cycle per second.
(1 cycle = 1 lock and 1 unlock)

b. Close, then open driver’s door.

4. Perform these steps within 40 seconds:

a. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles
starting with lock. Use an even pace and try to go about one cycle per second.
(1 cycle = 1 lock and 1unlock)

b. Insert the key in the ignition cylinder.

c. Turn the ignition to ON (as far as you can without cranking the engine)
then back to OFF

d. Remove the key from the ignition.

5. Within 3 seconds, the power door locks should cycle automatically indicating
successful entry into programming mode.
Return to step 1 if the locks do not cycle at this point.

6. Perform these steps within 40 seconds:

a. Press the lock and unlock buttons on the transmitter simultaneously for 1
second.

b. Immediately after letting go of the lock and unlock buttons, hit the lock button
by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle
once indicating successful programming. If the door locks don’t cycle, or cycle
twice, repeat steps a and b-your remote has not been accepted.

c. Repeat steps a and b in step 6 for each new transmitter.

7. Close door.

8. Grab Key and Remote, step out of car and test remote(s).

Disclaimer

Tip: It has been reported that some Avalons require trunk to be open during programming.