Vehicle Make

2000 Honda Passport Remote Programming instructions

Need A New Key Come Check Out Our
BRAND NEW ONLINE KEY STORE

visit our store

Shear These Programming Instructions



2000 Passport

  1. Open the driver’s door.
  2. Insert key into ignition.
  3. Turn the ignition switch to the ACC position and then to the LOCK
    position three times. (This step must be completed within 3
    seconds – go as fast as
    you can, or the system will not enter the
    programming mode.)
  4. Within 10 seconds, close and open the door two times.
  5. Turn the ignition switch to the ACC position and then to the LOCK
    position ***three times (again, do this within 3 seconds.)
  6. Within 10 seconds, close and open the door. Verify that the power
    door locks cycle once to confirm that the system is in
    programming mode.
  7. Within 20 seconds, press the LOCK button on the transmitter you
    are programming. Verify that the door locks cycle once.
  8. Within 20 seconds, press the UNLOCK button on the transmitter.
    Verify that the door locks cycle once to confirm that the system has
    accepted the transmitter’s code.
  9. Repeat steps 7 and 8 for each transmitter to be added.
  10. Remove key from ignition.

*** Some Passports require you to turn ignition on and off 5 times in step 5

Disclaimer