Vehicle Make

1999 Buick Century Remote Programming instructions

Need A New Key Come Check Out Our
BRAND NEW ONLINE KEY STORE

visit our store

Shear These Programming Instructions



IMPORTANT: Before entering programming mode, have in possession all of
the remotes you will be using on the vehicle. Once you program the remotes ,
all previous codes will be erased from the memory. The other remotes will not
be functional until you program the remotes again.


1. Close the vehicle doors.

2. Insert key in ignition and turn to ON (As far as you can without cranking engine)

3. Turn ignition OFF and remove the key from the ignition.

4. Press and hold the driver side door lock switch in the UNLOCK position.

5. Insert the ignition key into the ignition lock cylinder and remove the key.
(Do not turn the ignition key in the lock cylinder.)

6. Insert the ignition key into the ignition lock cylinder and remove the key.
(Do not turn the ignition key in the lock cylinder.)

7. Insert the ignition key into the ignition lock cylinder.
(Do not turn the ignition key in the lock cylinder.) Leave the
ignition key
in the ignition lock cylinder.

8. Release the door lock switch. The vehicle will sound three beeps in order
to verify the Program Mode has been activated.

9. Press the LOCK and UNLOCK buttons together on the keyless entry
transmitter and hold until the vehicle beeps twice to verify that the
transmitter has
been successfully programmed (this take approximately
15 seconds).


10.
Perform the previous step to program up to four transmitters (including your
old ones).

11. Remove the ignition key in order to exit the Program Mode.

Someone sent the following instructions for 1999 Century. If you have trouble with

the first set of instructions try these.

1. Sit in the driver's seat