Vehicle Make

1993 Ford Econoline Remote Programming instructions

Need A Refurbished Key Come Check Out Our
Refurbished On-line Key Store

visit our store

Shear These Programming Instructions

1. Turn ignition to RUN or ACC.

2. Jump pins in programming connector plug for entire programming
procedure. All doors will lock then unlock to confirm programming
mode. (The plug is black with two wires: white with yellow stripe and
gray with yellow stripe. The plug comes out of a large harness which
runs under the column at the bottom edge of the dash.)

3. Press any button on first keyless remote. Doors locks will cycle to
confirm programming.

4. If programming second keyless remote press any button on it and door
locks will cycle to confirm programming.

5. Turn ignition to OFF. Door locks will cycle to indicate end of programming
mode. 6. Remove jumper wire in programming connector.